Icom IC-W2E - Tuning and Dial Select Steps

5 SETTING A FREQUENCY
@ Setting a tuning step
The main dial or the A/V keys change the frequency in step
increments. Different tuning steps can be specified for the
VHF and UHF band.
The display shows
the 25 kHz tuning
step.
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Push [@ V/M] to select VFO mode. ('‘M”’ disappears.)
3) Push [(5) TS] to display the previously selected tuning step.
*5, 10, 12.5, 15, 20, 25, 30 and 50 kHz steps are available.
4) Rotate the main dial to select the desired tuning step.
5) Push [® CLR] to return to frequency indication.
@ Setting a dial select step
In VFO mode, while pushing the [F] key, the main dial changes
the frequency in 100 Hz or 1 MHz increments or changes the
memory channel according to the select step increment.
5.00 436i)
1 MHz Memory channel
100 kHz
The selected digit flashes.
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) While pushing [F], push (©) D SEL] to change the dial
select step.
* The selected digit flashes while pushing [F].