Icom IC-W2E - Setting Operating Frequencies; Frequency Setting Methods

es) ag RN ah Pa NT SEE at SO RL TEED
gg 5) 3=—Ss SETTING A FREQUENCY
@ Pre-operation note
VFO MODE
When the transceiver is not in VFO mode, frequency set-
ting is impossible. Push (@) V/M] or [(@) CALL] to select
VFO mode.
* Mode information is described on p. 21.
MEMORY MODE
vin Ma [wai] - renin
' ‘
VFO MODE 46.04 44G8d
ge
a;
M601 44208
110. t UU
Frequency can be set. ty — 4 -
c
Depending on CALL CHANNEL
the previous mode.
LOCK FUNCTION
When the lock function is activated, the main dial and key-
board will not function. Use the lock function to prevent
accidental frequency changing.
© While pushing [F], push [(@ LOCK] to turn the lock function ON
and OFF. If “L" appears, frequency cannot be set.
@ Using the main dial
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Rotate the main dial to set the frequency.
3) To change the frequency quickly, rotate the main dial while
pushing [F].
* See p. 17 ‘Setting a dial select step"’ for details.
@ Using A and V keys
1) Push [V MAIN] or [U MAIN] to select the desired band.
2) Push [A/SCAN] or [V/SCAN] to change the frequency.
* Holding the key for more than 0.5 sec. may activate full scan.
* If the scan is started, push [A/SCAN] or [V/SCAN] again to stop
the scan.