Icom IC-W2E - Code Programming Procedures

@ Code programming
¢ Before programming
Before operating the pager function, the following are neces-
sary for determining your group.
- ID code of each transceiver and the group code in your group.
~ Specification of “with code squelch” or ‘without code squelch"
for communication after contact.
¢ Channel assignment
“Receive accept"’ or
“Receive inhibit”
“Receive accept"’ only
“Receive inhibit’’ should
be programmed in each
channel.
One of C1~C5 “Receive accept" must be
programmed.
cP “Receive inhibit” only
* Channel CP automatically memorizes an ID code when
receiving a pager call. The contents in channel CP can-
not be changed manually.
RECEIVE INHIBIT
To receive the signal only you need, transmit code should be in-
hibit the reception, since the other station's ID codes are
programmed in transmit codes.
PAGER AND CODE SQUELCH 15
° Programming
1) Push [V MAIN] or [U MAIN] to select the desired band to
be programmed.
* VHF and UHF bands have separate code memory channels.
2) While pushing [F], push [C) CODE] to select the code
memory setting display.
3) Rotate the main dial to select the desired code memory
channel.
4) Push numeral keys to enter the desired digit codes.
5) Push [©PGRIC SQL] to set the channel for “receive in-
hibit’ (‘“SKIP” appears) or “receive accept” (‘‘SKIP"’ does
not appear).
* See the table at left for ‘receive inhibit’ or “receive accept”
details.
6) Push the selected band switch, [V MAIN] or [U MAIN] to
exit the setting display.