Icom IC-W2E - Pager Operation Procedures

ai
15 PAGER AND CODE SQUELCH
@ Pager operation
¢ Calling a specific station
1) Push [V MAIN] or [U MAIN] to select the desired band.
* The pager function cannot be turned ON simultaneously in the
VHF and UHF bands.
2) Push [C)PGRI/C SQL/ to turn the pager function ON.
*“PGR" appears.
3) Select the desired code memory channel to be used as
a transmit code:
- While pushing [F], push [(C)CODE].
~ Rotate the tuning control to select the channel.
- Push the selected band switch, [V MAIN] or [U MAIN], to exit
the setting display.
4) Push [PTT] to transmit the digit code.
5) Wait for an answer back.
© When the transceiver receives an answer back code, the func-
tion display shows the other station's ID or group code.
6) After confirming a connection, push the selected band
switch, [V MAIN] or [U MAIN], to display the operating fre-
quencies.
7) Push [©OPGRIC SQL] once to select the code squelch or
twice to select the non-selective calling system.
© Waiting fora call from a specified station
1) Push [V MAIN] or [U MAIN] to select the desired band.
* The pager function cannot be turned ON simultaneously in the
VHF and UHF bands.
2) Push [©OPGR/C SQL] to turn the pager function ON.
PGR" appears.
3) When receiving a call with a correct code, the transceiver
emits a beep and the function display shows the code as
shown on the page at right.
4) Push [PTT] to send an answer back call.
«The display shows the operating frequency.
5) Push [(QPGR/C SQL] once to select the code squelch or
twice to select the non-selective calling system.