Icom IC-W2E - Code Squelch Operation

PERSONAL CALL
When you receive a call
with your ID code and
received ID code is
“111,"" the display at
right appears.
| GROUP CALL
When you receive a call
with the group code of
“555"" and you have
pogrammed ‘‘555”’ into
code channel C5, the
display at right appears.
ERROR INFORMATION
When the transceiver
receives an incomplete
signal, ‘‘E" appears.
PAGER AND CODE SQUELCH 15
@ Code squelch operation
1) Push [V MAIN] or [U MAIN] to select the desired band.
* Code squelch cannot be turned ON simultaneously in the VHF
and UHF bands.
2) Push [©PGR/C SQL] twice to turn the code squelch ON.
*"C SQL” appears.
3) Select the code memory channel which contains the trans-
mit code or group code:
- While holding [F], push [© CODE].
~ Rotate the main dial to select the channel.
- Push the selected band switch, [V MAIN] or [U MAIN], to exit
the setting display.
4) Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
* 3-digit code is transmitted when pushing [PTT].
5) To cancel the code squelch, push [C)PGR/C SQL]
§|