Icom IC-W2E - Power-on Timer Configuration

14 CLOCK AND TIMER OPERATION
@ Power-on timer
The transceiver has a power-on timer to fit your schedule and
conserve battery power.
* Setting power-on time
GG 497.8E
nm
we
1) Enter CLOCK mode:
- Push [V MAIN] to select the VHF band.
- Push [© CLOCK] to access CLOCK mode.
2) Select the power-on display:
- Push [A/SCAN] to select the display as shown above.
3) Recall the previously set time:
- While pushing [F], push [@) MASK].
4) Set the power-on time:
- While pushing [F], push [() SET] to set the transceiver in the
time-setting condition.
- Rotate the main dial to set the hour.
- Push [A/SCAN] or [V/SCAN], then rotate the main dial to set
the minute.
- Push [@ ENT] to enter the time.
5) Exit CLOCK mode:
- Push [® CLR].
¢ Power-on timer operation
1. The power-on timer will turn power ON at the set time af-
ter power is OFF.
*5 beeps sound when the preset time arrives.
2. The preset time will be masked when the transceiver is
turned ON by the power-on timer.
* The programmed time is retained even after power is turned ON
by the [POWER] switch.
3. To deactivate the timer function, set the power-on time to
be masked. Repeat steps 1 ~3 in ‘Setting power-on time”
to select the masked display.