Icom IC-W2E - Transferring and Masking Memory Contents

@ Transferring memory
contents
The function copies and transfers the displayed memory con-
tents into the VFO. This function is useful for searching for
signals around the memorized frequency.
1) Select the memory channel to be transferred:
- Push [V MAIN] or [U MAIN] to select the desired band.
- Push [@) V/M] to select MEMORY mode.
- Rotate the main dial to select the desired memory channel.
2) While pushing [F], push and hold [@) MP V] until the tran-
sceiver emits 3 beeps.
*''M" disappears as VFO mode is automatically selected.
MEMORY OPERATION 9
@ Masking memory contents
Unwanted memory channels can be masked (hidden). A
masked memory channel cannot be selected for normal use.
The contents of the masked memory, however, can be
recalled by the following procedure.
Memory channel! 1 cannot be masked.
1) Select the memory channel to be masked:
- Push [V MAIN] or [U MAIN] to select the desired band.
- Push [@ V/M] to select MEMORY mode.
- Rotate the main dial to select the desired memory channel.
2) While pushing [F], push [(7) MASK] to mask the memory
channel.
3) To recall the masked memory contents, repeat step 2.