Icom IC-W2E - Programming Memory Channels

9 MEMORY OPERATION
@ Programming a memory
channel
1) Select the memory channel to be programmed: 2) Set the desired frequency in VFO mode:
- Push [V MAIN] or [U MAIN] to select the desired band. - Push (@ V/M] to select VFO mode.
- Push [@ V/M] to select MEMORY mode. (‘'M"’ appears). - Set the desired frequency to be programmed into the memory
- Rotate the main dial to select the desired memory channel. channel.
- To select blank channels, rotate the main dial while pushing [F]. - Duplex information can also be programmed.
3) While pushing [F], push and hold [@) MW] until the tran-
sceiver emits 3 beeps.
[EXAMPLE]: Program 145.375 MHz into memory channel 25.
V MAIN
Eo
6.88 YES 6.80 4F718C
VFO mode MEMORY mode MEMORY mode
Hold for 1 sec.
a
2) oO = aS
Puan]
com
M5 I% 4F1EE 5.9% WIE
25 =e5 38
VFO mode Set the frequency. VFO mode MEMORY mode (if desired)