Icom IC-W2E - Troubleshooting Guide

we
gum 1 7 TROUBLESHOOTING GUIDE
* No power comes on. * The battery pack is empty.
* Poor plug connection of the external DC pow-
er cable.
* Beeps sound and the power * The battery pack is empty.
cannot be turned OFF.
*No sound comes from the
speaker.
* A [SQL] control is turned too far clockwise.
* The battery pack is empty.
* Pager or code squelch is activated.
*No transmitting is possible or
only low power can be used.
* The battery is empty.
* The PTT lock function is activated.
* Low power is selected on the selected band.
* The lock function is activated.
* Frequency cannot be set.
* The call channel is selected.
* The call channel is selected.
© Priority watch is activated.
* Scan cannot be activated.
© The squelch of the selected band is open.
47
POSSIBLE CASE | souuTiION | EF. |
* Charge the battery pack or place new dry cell
batteries in the battery case.
* Check the connector or remove the cable.
*Detach the battery pack and charge the
battery pack or place new dry cell batteries
in the battery case.
* Rotate the [SQL] control counterclockwise.
* Charge the battery pack or place a new dry
cell batteries in the battery case.
* Push [©)PGA/C SQL] several times to turn
OFF the function.
* Charge the battery pack or place new dry cell
batteries in the battery case.
* While pushing [F], push [@ P.L] to cancel
the function.
*Push [(8) HI/LOW] to select high output
power.
* While pushing [F], push [@ LOCK] to turn
OFF the lock function.
* Push [@ CALL] to exit call channel mode.
* Push [@ CALL] to exit call channel mode.
*Push [© PRIO], to deactivate the priority
watch.
* Rotate the [SQL] control clockwise.
. 18
. 18
. 23
. 23
. 32
. 28