Icom IC-W2E - Clock and Timer Operations; Auto-Off Function and Clock Mode

play
mum 14 CLOCK AND TIMER OPERATION
@ Auto-off function
The transceiver automatically turns OFF after a selected peri-
od in which no switch is pushed or no signal is received.
¢ Selecting auto-off periods
[Aare] The display shows an
fA auto-off time period of
¥ 30 min.
Lain |
38 uy nr
m7
Only from the VHF band, this display can be accessed.
1) Select the auto-off display:
- While pushing [F], push (@) CLOCK/AO]}. Continue holding [F]
until step 2 is completed.
2) Select the auto-off time:
- While holding [F], rotate the main dial.
- 60 min., 30 min. and OFF can be selected.
- Release [F].
¢ Operation notes
1. The selected time is retained even after the transceiver
is turned OFF by the auto-off function.
2. To cancel the function, select ‘‘oFF’’ in step 2 above.
@ Clock mode
The transceiver is equipped with a clock for operating the
power-on and power-off timers.
When only the VHF band is selected as the main band, clock
and timer settings are available. Both the VHF and UHF
bands have a clock display.
6.80 497108
‘
CLOCK MODE
bwin)
(F309 4397.08
Power-off timer
Power-on timer