Care and Feeding an Icom PW1
W6DE
Copyright 2017, All rights reserved.
across the PA assembly (when assembled this bar is partially hidden by the combiner cables). In
addition there a lot of screws on the back panel. You also have to remove the back left corner foot to
slide the PA assembly forward (required in order to slide the PA forward because the foot’s screw
protrudes through the cabinet floor).
Make sure you mark every cable and take lots of cable routing and placement pictures first. Also note
where the shouldered screws go to hold the Filter assembly on the left side (a picture will help here).
To Next Page
Loading...
