ICON Health & Fitness Pro-Form Carbon T10 User Manual (English)

Questions and Answers:

N
Nathan PerezJul 29, 2025
How to fix ICON Health & Fitness Treadmill when the power does not turn on?
- K
  Keith RobertsJul 29, 2025
  If your ICON Health & Fitness Treadmill isn't turning on, ensure the power cord is securely plugged into a surge suppressor, which itself should be in a grounded outlet. If your outlet is AFCI-equipped and the breaker trips, consider purchasing an arc filter. Also, verify that the key is properly inserted into the console. Finally, check the power switch on the treadmill frame; if it's protruding, wait five minutes, then press it back in to reset it.
J
Jamie CoxAug 4, 2025
What to do if ICON Health & Fitness Pro-Form Carbon T10 power turns off during use?
- A
  Alexandria DavisAug 4, 2025
  If your ICON Health & Fitness Treadmill shuts off during use, first check the power switch and reset it if it has tripped by waiting five minutes and then pressing it back in. Ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, then plug it back in. Also, try removing and reinserting the key from the console.
D
Dr. Kim KeithAug 10, 2025
How to adjust ICON Health & Fitness Pro-Form Carbon T10 walking belt if it is off-center or slips?
- S
  Sarah PayneAug 10, 2025
  If the walking belt on your ICON Health & Fitness Treadmill is off-center or slips, first remove the key and unplug the power cord. For an off-center belt, if it's shifted left, turn the left idler roller screw clockwise 1/2 turn; if it's shifted right, turn it counterclockwise 1/2 turn. To fix a slipping belt, turn both idler roller screws clockwise 1/4 turn. After adjustments, plug in the power cord, insert the key, and walk on the treadmill to test. Repeat adjustments as needed until the belt is centered and properly tightened, allowing you to lift each edge 2-3 inches off the platform.
J
Jeremy MorrisAug 16, 2025
Why ICON Health & Fitness Pro-Form Carbon T10 Treadmill walking belt slows when walked on?
- C
  Connor Lewis MDAug 16, 2025
  If the walking belt on your ICON Health & Fitness Treadmill slows down when you walk on it, it might be overtightened. Remove the key and unplug the power cord. Then, use a hex key to turn both idler roller screws counterclockwise 1/4 of a turn. When properly tightened, you should be able to lift each edge of the belt 2 to 3 inches off the platform. Plug the power cord back in, insert the key, and test the treadmill. Repeat this process until the belt is correctly tightened.