THREAD SPIN SLEEVE
ONTO OUTER SLEEVE
CUT OUTER SLEEVE BACK 5”
THREAD SPIN SLEEVE BACK 10” CUT STAINLESS STEEL
CORE BACK BY 3”
9
FIGURE # 1.3 FIGURE # 1.4
FIGURE # 1.1 FIGURE # 1.2
DRIVE THREE STAINLESS STEEL
SCREWS, STARTING NEAR TOP
INSERT STAINLESS STEEL
CORE ONTO BREECH TUBE
FIGURE # 1.5 FIGURE # 1.6
To Next Page
Loading...
