ICS 890 Series - Cutting Ductile Iron Pipe with PowerGrit Chain

© 2014 ICS, Blount International Inc. Specications are subject to change without notice. REV021414 F/N 566100
890 SERIES OPERATOR’S MANUAL
13
CUTTING DUCTILE IRON PIPE WITH THE POWERGRIT
®
UTILITY SAW CHAIN
NEVER cut ductile iron pipe with the saw unless using PowerGrit Utility Saw Chain. The following
are safety precautions that should always be followed when using PowerGrit.
• Before cutting, make sure the pipe is in a safe condition to
be cut. Support the work piece in such a way that the cut
remains open during the cutting operation and when the cut is
finished. Pinching the chain during the cut could cause chain
breakage and could result in death or serious injury to the
operator.
• If using the pipe clamp accessory, the clamp must be
attached in such a way that it does not move during the
cutting operation and/or when the cut is finished. Unexpected
movement of the clamp could cause loss of control of the saw
and could result in death or serious injury to the operator.
WARNING
OPER ATION