© 2012 ICS, Blount International Inc. Specications are subject to change without notice. REV1112 F/N 70569
TITLESpeedHook
®
OPERATOR’S MANUAL
11
TROUBLESHOOTING
TROUBLESHOOTING
• LOOSE AXLE KNOB – Lock washer missing or not installed correctly. Lock axle into bracket by
reversing the washers (put lock washer against the axle).
• DIFFICULTY INDEXING - Keep the saw running at full RPM while indexing. Index before the saw
rotates fully 90 degrees into the wall.
• WATER NOT FLOWING - Water hose is kinked or supply is not turned on.
• SLOW CHAIN SPEED (hydraulic saws) - Be sure the power supply is providing 8 gpm (30 lpm)
and 2,500 psi (172.5 bar). The 853PRO Plus requires 12 gpm (45 lpm) fixed flow. Also, do not
apply excessive feed force.
• RESTART CUT - If the cut starts to become crooked, pull out, move down one or two hooks and
restart the cut. Connect the two cuts later by up-cutting.
Further questions?
Call 1.800.321.1240
or
visit our website at
icsdiamondtools.com
To Next Page
Loading...
