Manual IB-3640 Series
7
3. HDD INSTALLATION
- Please use the provided screws to secure the handles to the 4 HDDs.
- Open the front door.
- Press down the tabs (1) of metal frame to unlock and remove it.
- Take the transport paper board out of the device.
- Slide the 4 HDDs into the guide rails and push them downwards until it locks into the connector in
order from up to down.
- Reinstall the metal frame that was removed in step 3. Please make sure the bottom of the frame
stays inside the track (2) before closing the front door.
- Connect the power adapter and choose one cable to connect to your computer (depends on
version) and power on the device.
- When connected and powered on, the System LED will turn blue; the HDD LED lights will turn blue.
If there are HDDs, the HDD LED will stay blue. If the HDDs are accessed the corresponding HDD LEDs
will flash blue.
IB-3640SU3
- Power on the product and complete the setting inside Disk management of your computer system.
1
2
To Next Page
Loading...
Need help?
General