4
www.idealnetworks.net 163819
INTRODUCTION
The LanTEK IV and IDEAL AnyWARE are a Cable Certification System. This
guide will give you an overview of the key features of LanTEK IV and how to
start using AnyWARE to managed your project and test result.
GETTING STARTED
Before you start using your LanTEK IV follow the steps below to ensure you
can take advantage of all the features your LanTEK IV has to oer.
1. Fully charge the display and remote units using the power supply
included in your case. This can be connected to the main charging port
on the LanTEK IV or the quick charge port on the battery. The quick
charge port reduces the charging time by 50%. To access the quick
charge port the battery must first be remove by releasing the retaining
screw.
2. Select the language by selecting the setup gear at the top left of the
screen.
Handset charging
port
Status LED
Red = Charging
Green = Fully Charged
Quick Charge
Port
To Next Page
Loading...
