Need help?Do you have a question about the IDEAL Networks VDV II PRO and is the answer not in the manual?
Important warnings regarding electrical hazards and device damage.
Cautionary advice on using properly crimped plugs to avoid port damage.
Instructions for removing and inserting the battery in the tester.
Steps to turn the VDV II Pro tester on and off.
How to adjust the tester's backlight timeout settings.
Guide on connecting cables using specific ports and remote units.
Understanding display indicators for remote units and identifiers.
Procedure for testing cables and interpreting results on the display.
How to enable, disable, and understand split pair test results.
How to select between meters and feet for length measurements.
Setting NVP for accurate cable length measurements.
Steps to measure overall cable length and individual pair lengths.
How the tester detects and displays voltage information.
Interpreting voltage readings to identify PBX, ISDN, or other services.
How to start tone generation and select port/pins.
Methods to change tone type and control from the far end.
How to use Hub (Port) Blink to test Ethernet cabling.
Steps to turn off the Hub Blink feature.
How the tester detects and indicates Power over Ethernet sources.
Information on voltage and pin assignments for PoE detection.
Identifying advertised line rates and duplex modes of Ethernet devices.
How PoE presence affects the display of Ethernet device configuration.
Important warnings regarding electrical hazards and device damage.
Cautionary advice on using properly crimped plugs to avoid port damage.
Instructions for removing and inserting the battery in the tester.
Steps to turn the VDV II Pro tester on and off.
How to adjust the tester's backlight timeout settings.
Guide on connecting cables using specific ports and remote units.
Understanding display indicators for remote units and identifiers.
Procedure for testing cables and interpreting results on the display.
How to enable, disable, and understand split pair test results.
How to select between meters and feet for length measurements.
Setting NVP for accurate cable length measurements.
Steps to measure overall cable length and individual pair lengths.
How the tester detects and displays voltage information.
Interpreting voltage readings to identify PBX, ISDN, or other services.
How to start tone generation and select port/pins.
Methods to change tone type and control from the far end.
How to use Hub (Port) Blink to test Ethernet cabling.
Steps to turn off the Hub Blink feature.
How the tester detects and indicates Power over Ethernet sources.
Information on voltage and pin assignments for PoE detection.
Identifying advertised line rates and duplex modes of Ethernet devices.
How PoE presence affects the display of Ethernet device configuration.
General| Type | Cable Tester |
|---|---|
| Display | LCD |
| Display Type | LCD |
| Voltage Protection | Yes |
| Remote Identifiers | Yes |
| Supported Cable Types | Coaxial |
| Power Source | Battery |
| Cable Testing Functions | Length |
| Supported Standards | ISO11801 |
To Next Page
