Need help?Do you have a question about the IDEAL Networks SignalTEK NT and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Model | SignalTEK NT |
| Manufacturer | IDEAL Networks |
| Cable Support | Copper and Fiber |
| Display | Color LCD |
| Type | Network Tester |
| Connectivity | Ethernet |
| Standards | IEEE 802.3 |
| Supported Tests | Wiremap, Length, Ping |
| Power | Rechargeable battery |
| Testing Capabilities | Certification |
| Ports | RJ45 |
| Supported Standards | IEEE 802.3ab, IEEE 802.3u, IEEE 802.3 |
Essential safety precautions to reduce risk of fire, electric shock, and injury.
Safety status for RJ-45, USB, and DC inlet ports.
Managing power module charging, switching on/off, and saving.
Introduction to available Wiremap, Tone, and IP tests and their configurations.
Details on PoE, Ping6, TRoute6, and various performance tests.
Configuring IPv4/IPv6 addressing and RJ45/Optical ports.
Details unit pairing and report generation settings.
Understanding Cable and Ethernet modes for testing scenarios.
Wiremap test functionality, graphical results, and fault detection.
Cable performance testing and its results analysis.
Details on connectors, system ports, power, and controls.
RJ45 port setup, automatic mode selection, and test categories.
Details Link Mode, Remote Mode, and Link-Remote Mode tests.
Wiremap configuration, fault detection, and termination types.
Analysis of cable performance results and VoIP test details.
Configuring IPv4/IPv6 addressing and test parameters.
Setting up Ping and Traceroute tests with specific parameters.
Specifications for power, physical dimensions, environmental conditions, and approvals.
To Next Page
