EasyManua.ls Logo

IDEAL Networks SignalTEK NT - Network and SFP Configuration; IPv4;IPv6 and Port Configuration; Unit Pairing and Report Settings

IDEAL Networks SignalTEK NT
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SignalTEK NT 156875 Iss 3
User Guide Page 18
Enable/disable IPv4 and set IP address as static or dynamic (DHCP)
depending on which type your network supports. If Static is selected, enter
the numerical address, Netmask, Gateway, DNS1 and DNS2.
Enable/disable IPv6 and select ad
dress type as Static, Stateless, Stateful
(DCHP) depending on which type your network supports. If Static is selected,
enter numerical IP address, Prefix (64 or 128), Gateway, DNS1 and DNS2.
The factory set MAC address of the tester is displayed.
The skew between the Ethernet pairs is displayed. Skew is the delay (ns)
between the arrival time of the four pairs of the Gigabit Ethernet signals. It is
measured relative to the first signal to arrive, so that the displayed skew is
always zero for at least one pair.
NOTE
Both MAC and skew data are displayed for information only.
Provides the information that follows on the SFP connected to the Optical
port:
Status Available or Not Fitted, Vendor, Part number, Rx Power (dBm), Tx
Power (dBm).
See Supported SFP Transceivers below.
When first supplied, the Near-
End and Remote units are paired. When a
different or replacement Remote Unit is used, or the Near-End Unit has been
RESET to factory default settings, sele
ct PAIR from the set up menu and
press the soft key PAIR (F1). When the message ‘Remote detected’ is shown
on the display the units are paired indefinitely.
Provides the change of job reports parameters such as report format (PDF,
CSV), size (Summary, Brief and Full), results content level (All, Pass, Fail) and
wireless password.
See JOBS|OPTIONS|SETUP part on page 33 for details.
Supported SFP Transceivers
The SFP types that follow are supported. The use of other SFP types is possible but correct
operation is not guaranteed.
Type
Manufac
turer
Part No
Speed
Fiber
type
Waveleng
th
Connector
Type
SX Avago AFBR-5705PZ 1Gb/s Multimode 850nm LC Duplex
SX Apac LM28-C3S-TI-N-DD 1Gb/s Multimode 850nm LC Duplex
LX Avago AFCT-5705PZ 1Gb/s Singlemode 1310nm LC Duplex
LX Apac LS38-C3S-TC-N-DD 1Gb/s Singlemode 1310nm LC Duplex
ZX Apac LS48-C3U-TC-N-DD 1Gb/s Singlemode 1550nm LC Duplex

Related product manuals