IDEAL 3915-95 - Blade and Cutting Stick Replacement; Blade Replacement Procedure

- 20 -
IDEAL 3915-95
If the cutting quality decreases:
• Check the cutting depth (see page 28).
• Check the cutting stick (see page 24).
• Replace or grind the blade
(see page 20 - 28).
The blade cannot be ground if the blade
height is less than 33 mm/1,30 inches.
A new blade must be used.
The blade may only be grinded by a qualified
workshop or from the manufacturer
Krug & Priester, D-72336 Balingen.
Danger! Risk of injury
The blade is extremely sharp. Do not dismount
or transport the blade without protection.
Changing the blade may only be performed by
trained staff.
•
Blade and cutting stick replacement
•