IDEAL 4855 - Delete a Step

- 30 -
IDEAL 4855 • IDEAL 5255 • IDEAL 6655
T
MANUAL
•
Operation
• •
Adapting a program when the printer’s
imprint deviates
• Press PRG. RUN  "Load program no."
appears.
• Enter program number 01 ... 99, and with
2 x Enter
proceed to Step 1.
• Correct the cutting position of the backgauge
with the hand-wheel.
• MODIFY
V
appears on the screen and the
measurement ashes.
• To store press MODIFY .
• Release a cut and turn the paper.
• If the printer’s imprint deviates it can be
corrected during the rst two cuts via the
hand-wheel – see above.
• Correction is only possible during the rst two
cuts.
• After leaving the PRG. RUN mode the
original data is stored again.
Delete a step
• Press PRG. EDIT .
• Enter program number, conrm with Enter .
• Select program step with the arrow keys
b and j.
•
Scroll with STEP until "Delete step no."
appears, Press 2 x Enter
.