- 21 -
X
NP
O
E
F
G
• Operation •
• In memory 3 + 4 (mm and inch) no
measurements are saved. Until a rst input of
data the following will be shown in the
corresponding elds: . The
measurements entered remain stored.
They cannot be deleted but overwritten.
How to program Memory 3 and 4
Press the memory button
X to enter the
memory platform (3 or 4). Enter the required
measurements or overwrite them. Press the
button and keep it pressed until
an acoustic signal sounds, the
measurements have been saved now.
Warning!
Before storing or cutting a measurement
please check if the correct measurement scale
(cm or inch) see above is stored.
(7260 = 72.00 cm, 28.346 inches)
Is shown on the screen see
N.
After 30 minutes the machine (
A
B
C D
)
switches to energy-saving mode.
The machine is reactivated by touching the
keypad area
O.
Bright LEDs illuminate the working area (
D
).
The LED button (
E
) has 3 switching steps
Press 1 x
brightness 3
Press 2 x
brightness 2
Press 3 x
brightness 1
Light OFF
F
.
Optical cutting line indicator
A
(ON/OFF)
G
To Next Page
Loading...
