IDEAL 7260 - Page 22

- 22 -
P O
• Operation •
Cutting activation
Warning!
• Run backgauge to the front for turning the
paper stack
• Do not interrupt the upward movement of the
blade by performing switching procedures
• Wait until the display is green before
activating a cut
• Blade must always be at the top and be
covered by the clamp. Do not touch the
blade.
Risk of injury!
Cutting to specied dimensions
• Press MANUAL
• Enter dimension on the numerical
key pad O Measurement is shown in red
(If a wrong dimension is entered this can be
corrected by pressing the CLEAR button)
• Press START P  dimension is
approached, Measurement is shown
in green
• Insert paper and move by means of the
stacking angle
Q to the backgauge I and
side lay on the left
J
• Release the cut.
Cut according to markings
• Press MANUAL
• Adjust the backgauge with the
hand-wheel
G to the back
• Insert paper and move by means of the
stacking angle
Q to the backgauge I and
side lay on the left
J
• Turn the hand-wheel G to the right until the
marking on the paper to be cut is below the
cutting line indicator
• The further the hand-wheel G
is turned to the right, the quicker the
backgauge moves. If the hand-wheel is
turned to the left the backgauge will return
quicker.