PAGE 16 QUANTUM DI HEATER OPERATION / MAINTENANCE MANUAL
3.3.b Changing Heater IP Address
ATTENTION: This section of the manual assumes you know the basics
behind IP addressing. If you are unfamiliar with IP addressing, do not
attempt to change the IP address of the heater. Incorrect assignment of
an IP address could leave the Ethernet functionality of the heater
unusable by your current network configuration.
The heater ships with an IP address already assigned to it. The current
IP address of the heater can be viewed and changed from the heater
touch screen.
To view the current IP address and subnet mask of the heater, go to the
configuration screen in the touch screen. The IP address and subnet
mask are shown in the center of the screen.
To change the IP address of the heater, press the “IP Addr” button on the
right hand side of the configuration screen (see Section 4.2.e). A window
will open that will allow you to change the IP address and subnet mask of
the heater. Pressing the “Enter” button assigns the new IP address to
the heater. If you wish to cancel the changes made press the “X” button
at the top right of the window.
Please note that the new IP address is assigned as soon as the “Enter”
button is pressed. The previous IP address will also remain active until
power to the heater is cycled.
NOTE: Changing the IP settings may cause a WIN CE warning message
to appear. This warning is non-critical, and the heater will continue to
operate normally. To eliminate this warning message, do not hit “OK” or
“Cancel”. Instead, simply tap anywhere in the touch screen, outside of
the warning message.
To Next Page
Loading...
General