How to fix unable to display Live video on Idis Network Hardware?
If you're unable to display live video on your Idis Network Hardware, check the following: * Camera's video cable. * Monitor's video cable. * Camera's power setting. * Camera lens setting.
Why Idis DR-2100P main unit won't turn on?
If the main unit of your Idis Network Hardware won't turn on, make sure to check the power cable connection and the power outlet.
What to do if Idis DR-2100P NVR keeps on rebooting during a system upgrade?
If your Idis Network Hardware NVR keeps rebooting during a system upgrade, check the upgrade file's version. You can also try pressing the factory reset button without completing the upgrade. Note that a factory reset will clear all NVR settings configured by the user.
Why Idis DR-2100P PoE-enabled camera will not turn on?
If your PoE-enabled Idis Network Hardware camera won't turn on, first verify that the camera is actually PoE-enabled. Then, check the network cable; try replacing it and see if that resolves the issue.
General| Series | DR-2100P |
|---|---|
| Type | Network Video Recorder (NVR) |
| Video Input | Up to 32 channels |
| Hard Drive Bays | 8 |
| RAID Support | RAID 0, 1, 5, 6, 10 |
| Video Output | HDMI, VGA |
| Operating System | Embedded Linux |
| Compression | H.265, H.264, MJPEG |
| Power Supply | 100-240VAC, 50/60Hz |
| Max HDD Capacity | 6TB per HDD |
| Audio Input/Output | 1 input, 1 output |
| Network Interface | 2x Gigabit Ethernet |
| USB Ports | 2 x USB 2.0 |
| Remote Access | Web |
| Operating Temperature | 0°C to 40°C |
To Next Page
