What to do if Idis DR-6532P NVR stopped working during recording?
If your Idis Network Hardware NVR stops recording, the hard disk may be full. Try deleting video recordings to free up space. Alternatively, set the NVR to Recycle mode.
How to fix Idis DR-6532P when unable to display live video?
If you're unable to display live video on your Idis Network Hardware, check the camera's video cable connection, the monitor's video cable connection, the camera's power setting, and the camera lens settings.
How to troubleshoot Idis Network Hardware when the main unit won't turn on?
If the main unit of your Idis Network Hardware won't turn on, check the power cable connection and the power outlet.
Why is my Idis DR-6532P PoE-enabled camera not turning on?
If your Idis Network Hardware PoE-enabled camera won't turn on, verify that the camera is actually PoE-enabled. Also, check the network cable; replace it and try again.
General| Model | DR-6532P |
|---|---|
| Channels | 32 |
| HDD Bays | 8 |
| Audio Output | 1 x RCA |
| Power Supply | 100-240VAC, 50/60Hz |
| RAID Support | RAID 0, 1, 5, 6, 10 |
| Type | Network Video Recorder (NVR) |
| Video Input | 32 x IP Channels |
| Compression | H.265, H.264 |
| Network Interface | 2x 10/100/1000Mbps Ethernet |
| HDMI Output | 1x HDMI (up to 4K resolution) |
| VGA Output | 1 x VGA |
| Audio Input | 32 x IP Channels (via network) |
| USB Ports | 2x USB 2.0 |
To Next Page
