EasyManua.ls Logo

Idis DR-6532P - Video-Analytics_Motion

Idis DR-6532P
139 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Part 2 - Conguration
68
Video-Analytics_Motion
No.: Select which cameras to apply Motion Detection
to.
Zone: Dene the motion detection block.
Use the remote control’s arrow buttons to move the
block selection window up, down, left, and right. The
selection window consists of 8 blocks per row. Select/
deselect individual blocks using the Camera buttons.
You can use the mouse to drag the zone and then select,
clear, or reverse the selection.
From the zone selection screen, press the
button
on the remote control or right-click on the mouse to
open up the Zone Setup menu.
Select: Conrm the block selection in the selection
window.
Clear: Clear the block selection in the selection
window.
Reverse: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
Select All: Select all blocks.
Clear All: Clear all block selections.
Reverse All: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
OK: Save the changes and exit the menu.
Cancel: Exit the menu without saving the changes.
Setup
Sensitivity: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
Min. Blocks: Motion needs to be detected in more
than the specied number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under Zone for daytime and nighttime, each.
Ignoring Interval: The system does not produce
event log entries or remote notications for motion
detected within a certain period of time after the
motion of the camera channels is detected. Set the
value between 1 sec and 5 secs or choose Never.
Ignoring Interval does not aect motion detection
recording.
Daytime Setup: Specify when daytime starts
and ends. Adjust the time frame in 15-minute
increments. Times outside the specied range will
be assumed as nighttime by the system.
Detecting motion in PTZ movement: It can be set
to detect events during PTZ operation.

Table of Contents

Other manuals for Idis DR-6532P

Related product manuals