Idis DR-6532P - Idla_Line Crossing

Part 2 - Conguration
77
IDLA_Line Crossing
● No.: Select which cameras to apply Line Crossing to. It
is activated only when the analytic type is set to Line
Crossing in the Device - VA Box- Setup tab.
● CAM: Indicates the camera channel. VA BOX title is
displayed next to the camera channel number.
Refer
to the VA Box_Setup on page 88 for basic
information on setting the VA BOX.
● Line: Set a line to be detected.
You can set the line using the mouse. The line is
displayed in transparent.
Right-click on the line setup screen to bring up the
Intrusion Menu.
– Line Title: Select the line to change the settings.
When selecting the line, a check mark appears to
the left.
– Clear: Clear the selected line.
– Edit Name: Change the name of the line.
– Object: Select an object to detect.
– Direction: Select the direction of the obejct to
detect.
– Crossing Position Settings: Set the crossing
position of the object.
– Add: Add a line.
– Delete: Delete the selected line.
– Delete All: Delete all lines.
– Save: Save the changes and exit the menu.
– Cancel : Exit the setup screen without saving the
changes.
● Ignore Condition: Set the condition to ignore them
when the events occur.
– Ignore Condition: The system does not produce
event log entries or issue remote notications
regarding event for the specied time after the
initial event was detected. Set the value between 1
sec and 5 secs or choose Never. Ignore Condition
does not aect Line Crossing recording.
– Use Ignoring Time: Intrusion function will be
disabled during the specied time.
● Actions: Specify which actions to take when the
function is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels (each for the NVR and camera) and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, Push, FTP, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
– Event Monitoring: Selects the cameras to monitor
when an event occurs.
• In order to use the Callback feature, the NVR
must be registered on the remote program.
● When the analytic type is set to Line
Crossing in the Device - VA Box- Setup
tab, Use Ignoring Time option is not
dispalyed on the screen.
● To use the IDLA function, you need to set
up a time-lapse or pre-event recording
schedule in advance. Otherwise, the video
may not be displayed when searching the
event log.