How to fix unable to display Live video on Idis DR-6308P-SA Network Hardware?
If you're unable to display live video on your Idis Network Hardware, check the following: * Camera's video cable. * Monitor's video cable. * Camera's power setting. * Camera lens setting.
Why Idis DR-6308P-SA Network Hardware main unit won't turn on?
If the main unit of your Idis Network Hardware won't turn on, make sure to check the power cable connection and the power outlet.
What to do if Idis Network Hardware NVR keeps on rebooting during a system upgrade?
If your Idis Network Hardware NVR keeps rebooting during a system upgrade, check the upgrade file's version. You can also try pressing the factory reset button without completing the upgrade. Note that a factory reset will clear all NVR settings configured by the user.
Why Idis Network Hardware PoE-enabled camera will not turn on?
If your PoE-enabled Idis Network Hardware camera won't turn on, first verify that the camera is actually PoE-enabled. Then, check the network cable; try replacing it and see if that resolves the issue.
General| Channels | 8 |
|---|---|
| Maximum Recording Resolution | Up to 8MP |
| Compression | H.265, H.264 |
| Resolution | 3840 x 2160 |
| HDD Bays | 2 |
| RAID Support | No |
| USB Ports | 2 x USB 2.0 |
| Type | Network Video Recorder |
| Video Output | 1 x HDMI, 1 x VGA |
| Audio Input/Output | 1 x RCA Input, 1 x RCA Output |
| Storage | Internal HDD |
| Network Interface | 1 x Gigabit Ethernet |
| Alarm Input/Output | 4 x Alarm Inputs, 1 x Alarm Output |
| Operating Temperature | 0°C to 40°C |
| Power Supply | DC 12V |
| Video Input | 8 x IP camera inputs |
| Max HDD Capacity | Up to 12TB (6TB per HDD) |
To Next Page
