iDPRT SP310 - 3.4 LED indicators

-16-
Problem
Cause 
4. isalignment 
Skip label.
The printer is
uncalibrated.
Calibrate the printer.
ethod 1: Tools --- "Automac label
learning".
ethod 2: Press and hold the feed buon
top buon) unl the blue light goes out
twice and then release
..
The tag format is incorrect . Check your label format and correct it as
needed.
5.Paper am. The paper is not placed
correctly in the printer. .
Open the printer coer and remoe the
ammed paper. Then clean the print head,
paper sucon port and place the new
paper.
6. The paper is not
sucked in by the
printer.
7. The label or image
is oset during
prinng.
The paper does not
conform to the
specicaons.
Use the paper that meets the
specicaons.
Printer uncalibrated.. Calibrate the printer.
The platen is too dirty. Clean print head and platen.
The calibraon of the
paper sensor is incorrect.
Calibrate the printer.
The loading of the media
is incorrect.
nsure that the media is properly loaded.
The media is incompable.


The paper is not detected
by the paper sensor in the
middle of the printer.
When placing paper from the back entry slot,

sensor, and the paper sensor will trigger

paper is detected.
The printer uses a



Set the printer as the correct medium type.