IDROBASE Stella - Page 58

58
9.3 PLANNED MAINTENANCE
General test (to be carried on using the equipment accessories of the machine): pressure, temperature, electric absorption, regu-
lation of the detergent ow. Times of maintenance and replacement of the components are calculated in multiples of 250 hours,
so that interventions become standard and you have a programmed maintenance of the pressure washer. If we ll a schedule with
the components that need maintenance or replacement in order of the usage (250, 500, 750, 1000 hours), the result you will get is
a plan of programmed work, as follows in the enclosure.
Service at 250 hours
Check Components Replace Clean Set
In line fuel lter
Fuel pump lter
Electrodes
Burner combustion
Fuel pressure
Unloader valve
Safety valve
H.p. nozzle
Quick couplings
Inlet water lter
Pump oil (1
st
time) after 50 hours
Service at 500 hours
Check Components Replace Clean Set
Pump valves
Seal packing
In line fuel lter
Fuel pump lter
Fuel nozzle
Electrodes
Spark plug
Fuel tank
Burner combustion
Fuel pressure
Unloader valve
Safety valve
H.p. nozzle
Quick couplings
Inlet water lter
9  MAINTENANCE
Copyright ©2016 Idrobase Group. All rights reserved.