Operation
10
p.13
1. Once the power is applied, three beeping sounds can be heard and the LED toggles the
color to red-green-red indicating that the reader is in standby mode after a successful in
itialization and diagnostics
2. Present proximity card to the reader until you hear a beep sound. The LED is changing t
he color to Green simultaneously and sends the RF card data to the controller. Afterwar
ds the LED changes the color to red again for the next reading.
3. LED Control:
To change the LED colors, you may connect the LED Control Input (Yellow wire) to pow
er ground. The green LED is indicating that the reader is in standby mode.
Present proximity card. The LED changes the color to red simultaneously, then to green
again for the next reading.
4. Buzzer Control:
When the reader reads the proximity card, one beep sound generates in normal operati
on mode, but you can generate more beep sounds to distinguish whether the access is
granted or denied.
To generate more beeps, you may control the Buzzer Control Input (Blue wire) to power
ground.
Afterwards you can turn the beeper on, while holding the Buzzer Control Input to powe
r ground.
To Next Page
Loading...
