IEC 30 Series - Page 38

SECTION 4
Table 4-2. Calibration and Performance Checks (Continued)
Step Calibration Control Setting
Test
E1uiPment
Mode)
Procedure
1.
Connect 3v p-p sine-
wave @ 50 Hz to TRIG/
SYNC input.
2.
Observe waveform as
shown on scope at
OUTPUT BNC.
(Approximately 20
cycles of Triangular
wa vefor m with
decreasing period. )
1. Remove the sinewave
from the TRIG/SYNC
BNC.
2.
Observe on the scope
the repeating swept
waveform as shown at
the output BNC.
Rotate the TRIGGER
LEVE L pot from stop to
stop. Observe that any
number of complete cycles
may be produced from one
to 10 before repetition.
16.0
*16.1
SWEEP MODES
TRIG SWP
Mode
MODE
@ Trig Swp
SWP TIME
@ 10 ms
SWP VERN @ Cal
FREQ Mult @ 1K
FREQ Dial @ 1. 0
SWP LIMIT
Dial
@ 3.0
WAVEFORM @
Triangle
Function
Generator
Scope
*16.2
CONT SWP
Mode
MODE
@ Cant Swp
*16.3
BURST Mode MODE @ Burst
~
~
4-12