WHY DOES IT HAPPEN ?
WASHING MACHINE DOOR DOES NOT OPEN
•
• Check if the door Green led is . check if the child lock is active
• For reasons of safety, the washing machine door cannot be opened when the water level, temperature or the speed is too
high
MACHINE DOES NOT START
• Check if the machine is powered ON.
• Check if the “Start/Pause” button is ON .
• Check water supply.
• Porthole door not closed properly.
WATER DOES NOT ENTER MACHINE/DETERGENT NOT BEING FLUSHED INTO DRUM
• Check water supply
• Porthole door not firmly closed
• Water tap not turned on
• Bent inlet hose
• Sieve on inlet valve/ inlet hose clogged.
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY
• Detergent used is not a washing machine detergent
• Excessive detergent used
WATER LEAKAGE FROM THE MACHINE
• Inlet/Outlet hose connection loose
• Coin trap not screwed on properly
• Inlet hose leaking
MACHINE DOES NOT DRAIN
• Coin trap clogged
• Outlet hose end above 1 meter. from floor level
MACHINE DOES NOT SPIN/ CLOTHES REMAIN WET.
• Rinse Hold option is selected
• Coin trap is clogged.
• Unblanced load ( Divide the load in two halfs and spin each load using exclusive spin program with desired spin
speed or add smaller articles of laundry to balance the load & repeat the spin cycle.)
• Excessive detergent / Foam
• Load is too small.
MACHINE VIBRATES MORE DURING SPINNING
• Machine not leveled properly
• Coin trap clogged partially.
• Clothes not loaded as instructed/ unblanced load.
MOTOR NOISE
• It is normal for noises to be heard while motor is running. However wash load, belt tension and motor mounting bolt should be
checked for specified limits.
PUMP NOISE
• It is normal for noises to be heard from the pump during the start-up and final stage of draining. However check for fluff
filter clogging.
PROGRAM CYCLE TIME DELAYED
• Not a fault
• It is normal as the washing time may vary depending upon the type and quantity of laundry, inlet water pressure, inlet
water temperature, variations in power supply and other usage conditions.
• If there is unblanced load the machine may make several attemps to redistribute the clothes inorder to minimize the
vibrations resulting in extended program duration.
Check if the program is active.
glowing
/ EXCESSIVE FOAM IN THE
DRUM.
22
To Next Page
Loading...
Need help?
General
