IFM Electronic AS-i DP Series - Page 11

device manual AS-i DP - Gateway
Choose the op
tion "Change Address" and the desired AS-i master in the menu "Address Slave".
The first slave which is detected (i.e. the slave with the lowest address) is displayed. Since in this case
only one slave is connected the indicated address can only be that of this slave. Pressing the ‘OK‘
button causes the first free slave address to be displayed (generally the address 0.) The desired new
address can be chosen using the arrow buttons. The confirmation is initiated with the ‘OK‘ button,
after which the selected addresses are redisplayed. If this address is not correct, the addressing
procedure can be terminated with ‘ESC‘. If the address is the one desired, press ‘OK’ and the
addressing process will be completed.
Change Address
Easy Startup
OK ESC
Addr. Slave of
AS-i Master 1
AS-i Master 2
OK ESC
Curr. Slave Addr.
AS-i Master 1
5
OK ESC
New Slave Addr.
AS-i Master 1
0
OK ESC
Change Address
Master 1
Cur. Slave Addr. 5
New Slave Addr.
0
OK ESC
Addressing done
Master 1
Cur. Slave Addr. 5
New Slave Add
r.
0
NEXT
ESC
4-11