IFM Electronic AS-i DP Series - Menu Structure

device manual AS-i DP-Gateway
4.4.1 Menu structure
Start display (AS-i Error Diagnostic)
press ‚Menu‘ button 
 Slave Lists: check the addresses of connected AS-i slaves
- See list of detected AS-i slaves (LDS)
- See list of projected AS-i slaves (LPS)
- See list of activated AS-i slaves (LAS)
- See list of periphery faults on AS-i slaves (LPF)
 Slave addresses: programming of the addresses of the connected AS-i slaves
- Readdress AS-i slaves connected to AS-i DP -Gateway
- Address new AS-i slaves to the next free address automatically (Easy Startup)
 Quick Setup: everything needed for basic configuration
- Teach in the current AS-i configuration (Config all)
- Setup the field bus connection
 System Setup: setup the AS-i DP -Gateway device
- Save current system settings
- Setup the baud rate of the serial programming port (AC1326 only)
- Update the firmware of the AS-i DP -Gateway (requires special software)
 System Info: device information
- See the hardware and firmware version numbers of this AS-i DP -Gateway
- See the serial number of this AS-i DP –Gateway
 Diagnostics: Information for System Diagnostics (AC1335 only)
- Read the configuration error counter of the connected AS-i system
- Read the telegram error rate of the connected AS-i system
- Reset the configuration error counter
- Display transmission errors to the connected AS-i system
 Master Setup: information on AS-i master system
- Teach in the current AS-i configuration (Config all)
- Change to projecting mode: Configure the AS-i system
- Change to protected mode: normal operation (master checks configuration)
- Enable automatic AS-i slave addressing in protected mode
- Disable AS-i reset when activating protected mode
- See the counter of config errors in the connected AS-i systems (AC1326)
- Reset the counter of config errors (AC1326)
- See the rating of faulty AS-i telegrams in the connected AS-i systems (AC1326)
 Slave Setup: detailed information about the connected AS-i slave
- See the digital or analogue I/Os of the connected AS-i slaves
- See the parameters of the connected AS-i slaves
- See the I/O and ID codes of the connected AS-i slaves
- See the telegram errors related to the connected AS-i slaves
 Field bus Setup: the different field bus interfaces are optional
- Setup the node address of the AS-i DP -Gateway in the high level field bus
- Setup other settings if neccessary in the used high level field bus
4-14