device manual AS-i DP - Gateway
5 Profibus DP configuration
The AS-i DP -Gateway AC1325/AC1326 is a modular Profibus DP slave. To set up the Profibus DP
slave address select the menu "field bus setup" in the AS-i DP -Gateway display. The new address is
stored non volatilely in the device.
Profibus DP- Gateway with 2 AS-i Master (AC1326)
SmartLink DP with 1 AS-i Master (AC1335)
In the programming software for the Profibus DP master system the data to be transferred to the AS-i
DP -Gateway or the connected AS-i systems can be defined by indicating the length of up to 12
modules.
The GSD file ifm_04D8.gsd for AC1326 contains different possible definitions (indicated lengths) for
each of the 11 modules, the file ifm_07E5.gsd for AC1335 contains different possible definitions for
12 modules. You can find the GSD file in the hardware catalogue of the Profibus configuration
software in the folder Gateway.
The double master AC1326 uses the GSD of the controller
e
family which is listed in the hardware
catalogue as "ASI-DP-Controller e" and supports 11 modules. The single master AC1335 is indicated
in the hardware catalogue as "ASI-DP-Gateway" and supports an additional module 12 if using GSD
revision 2 and device firmware version 1.23 or higher.
5.1.1 Definition of the Profibus DP module
The texts of the different options of the modules always start with the module number. All options in
the module list of the hardware catalogue starting with 1: are thus options of the first module in the
device definition.
5-15
To Next Page
Loading...