Need help?Do you have a question about the IFM Electronic PN2 Series and is the answer not in the manual?
General| Brand | IFM Electronic |
|---|---|
| Model | PN2 Series |
| Category | Accessories |
| Language | English |
Explains how the switching outputs change status based on set limits and hysteresis or window functions.
Describes the analogue output configuration for OUT2, including voltage and current signal settings.
Outlines the three-step process for setting any parameter on the device.
Provides instructions for configuring output signal behavior and limits.
Details how to configure the switching functions for OUT1 and OUT2, including output off.
Explains how to set the upper (SPx) and lower (rPx) limits for hysteresis switching functions.
Explains how to set the upper (FHx) and lower (FLx) limits for window switching functions.
Describes how to set the analogue start (ASP2) and end (AEP2) points for the output signal.
Details the procedure for performing zero-point calibration of the sensor.
Explains how to reset all device parameters and the operating mode to their factory defaults.
Covers functions for monitoring device status and performance.
To Next Page