5. OPERATING
5.1. First Fire
•
The pellets feeder, not provide the required number of pellets in the tank is not full
every first firing. So the pellets tank, make sure that the pellets fall into the
pellets
feeder.
•
If not successful after several test burn, make sure
of
the correct positioning of the
combustion pot.
•
Instead of the igniter is placed in the holes in the pot. Burning pot, make sure it is
fully seated.
•
Please check. Pellets left over from previous combustion and / or residues, can be
an
obstacle to burn pellets stuck to the firing rod. If an abnormality is found
again
after these checks, there may be a problem with the stove components or
installation means correctly.
For warning labels affixed on the stove, remove before burning
stove.
During the first burning stove clean room air intake must be
provided.
The smoke and odor of the protective paint on the stove during
the first combustion is short term, in this case open the doors and
windows.
To Next Page
Loading...
