The pellets are not as much
as they should feed into the
combustion chamber, or less.
• The pellet hopper is empty.
• Pellet Feeder is blocked by screw and / or sawdust
(dust).
• The engine is faulty.
• Defective electronic card
• Empty and refill the pellet hopper.
• Feed the Pellet Feeder through obstacles such as
chips.
• Replace the pellet feeder motor.
• Check the electronic board.
The pellets are stacked in the
combustion bowl, the cover
glass becomes dirty very
quickly, and the flames
appear weak.
• Insufficient combustion air.
• Pellets may be damp or unsuitable.
• The fume extractor motor may be defective.
• Check that the room is permanently edible with
clean air.
• Clean the combustion bowl and check that the air
vents are open.
• Clean the combustion chamber and clean the
smoke duct.
• Check that the cover seals fit properly.
• Check that the pellet is seated in the correct
location.
• Change the pellet type.
• Check the Chimney Fan motor if it is not working.
The flue fan discharge motor
does not work.
• The stove may also be a source of electricity.
• The motor supplying the chimney fan may be
damaged.
• The electronic card may be defective.
• The control panel may be broken.
• Check the power supply phase and voltage.
• Check the motor capacitor and replace if
necessary.
• Replace the electronic motherboard.
• Replace the control panel.
The convection air fan
operates continuously.
• The temperature sensor is defective or defective
• The fan may be defective.
• Check engine operation and replace if necessary.
• Check sensor operation and replace if necessary.
The baked products are
burning.
• Improper use of shelves inside the oven
• Place the oven pan correctly.
• Select the correct power according to the product being
cooked.
To Next Page
Loading...
