31
RELAYS
SENSOR
RELAYS
SENSOR
RELAYS
SENSOR
The Relay TEST Function
The relay comms test function is similar to the detector comms test. This function is a
diagnostic check which provides information regarding the ability of the Tocsin 750 controller
to communicate to all its connected detectors.
To run the test, select the range of relays you wish to test and then how many communication
cycles to run the test for (typically 1000).
When relay test is selected the following diagnostic screen is displayed.
The display shows eight relay channels at a time. Use the NEXT & PREVIOUS keys to
display more channels. The return key ends the diagnostic.
Select the starting relay
Select the Finishing relay
Select how many communication
cycles to run the test for.
To Next Page
Loading...
