iGenix IG2095 - Advanced Cooking and Programming; Multi-Stage and Pre-set Cooking

7
Multi Stage Cooking
Some recipes may require setting a multi-stage program involving defrosting, and different power levels. The
following example shows the steps in setting up such a program:
Example: If you want to defrost the food for 5 minutes, then to cook with 80% microwave power for 7
minutes. The steps are as follows;
1. Press ‘W.T./TIME DEFROST’ twice, the screen will display ‘dEF2’
2. Turn the control dial to adjust defrost time of 5 minutes
3. Press ‘MICROWAVE’ once
4. Turn the control dial to choose 80% microwave power ‘P80’ will be displayed
5. Press ‘START/+30SEC./CONFIRM’ to confirm
6. Turn the control dial to adjust the cooking time to 7 minutes
7. Press ‘START/+30SEC./CONFIRM’
NOTE:
The buzzer will ring after each stage and the next stage will begin
Pre-set Function
The Pre-set function allows you to programme in a desired cooking program and set it to start at a delayed
time.
1. Make sure that the clock has already been set. Please see ‘Setting the Digital Clock’ instructions.
2. Input the desired cooking program. Two stages can be set at the most. Defrost should not be set in a
preset function.
Example: If you want to cook with 80% microwave power for 7 minutes.
1. Press ‘MICROWAVE’ once
2. Turn the control dial to choose 80% microwave power until ‘P80’ is displayed
3. Press ‘START/+30SEC./CONFIRM’ to confirm
4. Turn the control dial to adjust the cooking time to 7 minutes
5. After the above steps please DO NOT press ‘START/+30SEC./CONFIRM’ but do as follows
6. Press ‘CLOCK/PRE-SET’ the minute figure will flash
7. Turn the control dial to adjust the minute figure the input time will be between 0-59 minutes
8. Press ‘START/+30SEC/CONFIRM’ to finish setting ‘:’ will light, the buzzer will ring twice when the time
arrives, then cooking will start automatically.
Child Lock
To set the lock press ‘STOP/CLEAR’ for 3 seconds, there will be a long ‘beep’ denoting entering the child-
lock state. The screen will display the locked indicator.
To release the lock press ‘STOP/CLEAR’ for 3 seconds, there will be a long ‘beep’ denoting the lock is
released.
Auto Menu
1. With no other setting applied, turn the control dial to the right to choose a menu between A-1 and A-8
(Please see table below of menu functions)
2. Press ‘START/+30SEC./CONFIRM’ to confirm the menu you choose
3. Turn the control dial to choose the food weight
4. Press ‘START/+30SEC./CONFIRM’ to start cooking
5. After cooking has finished, the buzzer will sound 5 times.