iGenix IG2590 - Operating Instructions - Advanced Functions

13
b) If cooking time has not been entered within 5 minutes, the oven will stop preheating. The appliance
will beep ve times and return to standby mode.
Note: To check the selected function whist in cooking mode press “CONVECTION” button, then the
current function code will be displayed for 2-3 seconds.
Convection cooking (without preheating function)
1) Press the “CONVECTION” button once, “150°C” ashes.
2) To increase the temperature, continue to press the “CONVECTION” button or turn dial until
desired temperature displayed.
Note: Please refer to cookware guideline table for suitable containers
3) Press the “START/+30SEC./CONFIRM” button to conrm the temperature.
4) Turn the dial to adjust the cooking time. (Maximum is 95 minutes)
5) Press the “START/+30SEC./CONFIRM” button to start cooking.
Note: To check the selected function whist in cooking mode press “CONVECTION” button, then the
current function code will be displayed for 2-3 seconds.
Defrost by Weight
1) Press “W.T./TIME DEFROST” button once, the display will show “d-1”
2) Turn dial to select the required weight. The weight should be 100-2000g
3) Press “START/+30SEC./CONFIRM” button to start defrosting.
Defrost by Time
1) Press “W.T./TIME DEFROST” button twice, the display will show “d-2”
2) Turn dial to select the cooking time. The maximum setting time is 95 minutes.
3) Press “START/+30SEC./CONFIRM” button to start defrosting.
Quick Start Cooking
In Standby mode press “START/+30SEC./CONFIRM” button to cook with 100% power level for 30
seconds. Each press on the same button will increase timer by 30 seconds.
OR
In Standby mode turn the dial left to choose cooking time, then press “START/+30SEC./CONFIRM”
button to cook with 100% microwave power.
Multi Stage Cooking
The oven can be programmed to perform up to 2 separate cooking sequences. Ideal for defrosting and
cooking food (defrosting must always be stage 1 of the sequence).
The appliance will beep once after the rst stage of the sequence and then ve times to indicate the end
of both sequences.
Note: Auto menu and preheating cannot be set as one of the multi stage sequences.
Example: if you want to defrost the food for 5 minutes, and then cook with 80% microwave power for
7 minutes, the steps are as follows:
1) Press “W.T./TIME DEFROST” twice, the screen will display “d-2”.
2) Turn the dial to adjust the defrost time to 5 minutes.
3) Press “MICROWAVE” once.
4) Turn the dial to choose 80% microwave power until “P80” is displayed.
5) Press “START/+30SEC./CONFIRM” to conrm.
6) Turn dial to adjust the cooking time to 7 minutes
7) Press “START/+30SEC./CONFIRM” button to start cooking.