11
back to standby mode.
• Press the Timer button, the On light will then illuminate.
• Use the Humididty/Hours buttons to select the desired amount of time until
you would like the appliance to switch on (the LED display will show the
hours).
• The selected time will be registered after 5 seconds and the LED display will
revert back to displaying the Relative Humidity of the room.
• The appliance will switch on after the selected period.
How to use the Timer to switch off the appliance:
• Plug the appliance into a suitable wall socket – the appliance will beep once
and will remain in Standby Mode.
• Press the Stand-By button to switch on the appliance.
• The illuminating LED will automatically display the Relative Humidity of the
room; you can now select the desired function.
• Once function is selected, press the Timer button, the Off light will then
illuminate.
• Use the Humidity/Hours buttons to select the desired amount of time until
you would like the appliance to switch off (the LED display will show the
hours).
• The selected time will be registered after 5 seconds and the LED display will
revert back to displaying the Relative Humidity of the room.
• The appliance will switch to standby mode after the selected period.
FROST PROTECTION: When frost builds up on the evaporator coils,
the compressor will cycle off and the fan will continue to run until the frost
disappears.
AUTO-RESTART: If the appliance stops unexpectedly due to a power cut,
it will restart when the power resumes with the previous function selected
automatically.
To Next Page
Loading...