iGenix IG9851 - Functions; AUTO Mode; MANUAL Mode; TURBO Fan Speed

10
Functions
AUTO: Use this mode for automatic dehumidication. In this mode, the desired
humidity cannot be adjusted, however the fan speed can be changed at any time
by pressing the Turbo button.
MANUAL: Use this mode to manually select the desired humidity level
(between RH35% and RH85%) and Fan Speed (Normal/Turbo)
• Press the Stand-By button to switch the appliance to ‘On’.
• Set the desired humidity using the Humidity/Hours buttons on the control
panel.
• Press the Manual button to begin dehumidication.
• The fan speed can be changed at any time by pressing the Turbo button.
Note: It is not possible to change the desired humidity after the Manual button
has been pressed and dehumidication has commenced, unless the current
dehumidication program has been cancelled.
• Press the Manual button to cancel the program.
• Select desired humidity using the Humidity/Hours buttons on the control
panel.
• Press the Manual button to begin dehumidication.
TURBO: Press this button to alternate between the appliance’s two fan speeds.
When the light above the button is illuminated, the fan will run at a high speed to
ensure maximum moisture removal. When the light above the button is off, the
fan will run at a normal speed and the operation of the appliance will be quieter.
TIMER: The 24 Hour programmable timer can be used to switch on the
unit after a desired period of time; or can be used to switch off the unit after a
desired period of time.
Note: The timer can be selected between 1 to 24 hours, in increments of 0.5
hours between 0 to 9.5 hours, and in increments of 1 hour between 10 to 24
hours.
How to use the Timer to switch on the appliance:
• Plug the appliance into a suitable wall socket – the appliance will beep once
and will remain in Standby Mode.
• Press the Stand-By button to switch on the appliance.
• The illuminating LED will automatically display the Relative Humidity of the
room; you can now select the desired function.
• Once function is selected, press the Stand-By button to switch the appliance