13
CLEANING AND MAINTENANCE
Always switch off the unit and unplug from the mains socket before cleaning or
performing any maintenance. When not in use for long periods it is also advisable
to remove the plug from the power socket.
Wipe the outside of the unit with a soft, damp cloth. A mild detergent may be
used if necessary. Dry with a cloth. Do not use any harsh abrasives or solvents.
Never immerse this appliance in water or any other liquid.
The air lter should also be cleaned regularly. To remove the lter:
• Grip the bottom tab of the lter and pull outwards to
remove from the back of the unit.
• To dislodge any dust from the lter, you can either tap lter
lightly over a dustbin or use a vacuum cleaner to remove all
dirt.
• Wash the lter in warm soapy water (using a neutral
detergent), rinse well with clean water and then leave to
dr y.
• Once the lter is thoroughly dry, reinstall the air lter
securely into the back of the appliance.
• Press the Filter button to reset and the light will go off.
The water tank should be cleaned every few weeks to prevent growth of mould,
mildew and bacteria. Partially ll the tank with clean water and add a little mild
detergent. Swish it around and then empty the tank and rinse.
To thoroughly clean and dry the tank you can remove the handle and lid to gain
access to the inside of the tank.
Follow these instructions:
Move handle to
this position
Detach the handle Remove handle
and water tank
cover
You can now
access inside of
water tank
Note: After cleaning, drying and reassembling the water tank, it must be
reinserted securely into dehumidier in order to restart operation.
To Next Page
Loading...