Ice Cream/ Gelato Cases| www.igloorefrigeration.com
- Use the UP and DOWN buttons to scroll the parameters. The LED corresponding to the category of parameters will
be on;
- Press SET to display the value associated with the parameter
- Increase or decrease the value using the UP or DOWN button respectively;
- Press SET to temporarily save the new value and display the parameter again;
- Repeat the procedure for any other parameters that need to be modified;
- Press the SET button for more than 3 s to permanently save the parameters and exit the parameter setting
procedure.
Table 4 Table of easy compact parameters for ARB2F & ARBF
probe measurement stability
select direct/reverse operation
night-time set point delta
compressor and fan start delay on power-up
minimum time between consecutive compressor starts
minimum compressor off time
minimum compressor on time
compressor on time with duty setting
continuous cycle duration
temperature alarm bypass after continuous cycle
interval between defrosts
end defrost temperature set point
defrost when switching the instrument on
defrost delay on power-up or when enabled by digital input
freeze control temperature display during defrost
alarm bypass time after defrost
defrost priority over compressor protectors
defrost probe reading (2)
alarm and fan temperature differential
absolute/relative temperature for low temperature alarm
absolute/relative temperature for high temperature alarm