Why does the Igloo ICE102-WHITE “ADD WATER” light turn on?
The “ADD WATER” indicator light illuminates because the water level is low, or there is a lack of water. Add water, and the Igloo Ice Maker will resume operation automatically.
What to do if my Igloo ICE102-WHITE Ice Maker does not operate?
First, ensure the Igloo Ice Maker is plugged into a standard 110/120 Volt, 60 Hertz power source. Also, the appliance should be run in temperatures below 90°F, and colder water should be poured into the water reservoir.
How to turn off the “Ice Full” indicator light on my Igloo ICE102-WHITE Ice Maker?
The “Ice Full” indicator light is on because the ice basket is full. Simply remove ice from the ice storage basket to allow the Igloo Ice Maker to make more.
How to fix an ice blockage in my Igloo ICE102-WHITE Ice Maker when no ice is being made?
Ice blockage occurs because making ice takes too much time. Turn off the Igloo Ice Maker. After the ice block melts, restart the machine. Alternatively, change the size selector to produce smaller ice cubes.
What to do if the “Ice Full” and “Add Water” lights are on at the same time on my Igloo ICE102-WHITE Ice Maker?
This can occur due to an electrical power surge, air in the lines, blocked lines, or the water tank's inability to detect the water level. Try the following steps: 1. Turn off the Igloo Ice Maker and unplug it. 2. Fill the unit with water if needed, then replace the plug and restart. 3. Inspect the parts; remove the drain cap on the back to drain a small amount of water, then replace the cap and try again. 4. Check for ice blocking the ice pusher; turn off the unit to let the ice melt, then restart.
Why is there no display on my Igloo ICE102-WHITE control panel?
The control panel may not be lit because the plug is disconnected. Check that the plug is properly inserted into the electrical outlet.
Details on the 15 AMP 110-115 VOLT 60 Hz grounded outlet and 3-wire cord.
Explains the control panel functions including LED indicators and buttons for ice size selection.
Details the drain cap, rubber plug, and drain spout for water removal.
Guidance on proper placement, leveling, and initial setup before first use.
Steps for filling water, starting the unit, and selecting ice cube size.
General| Product Type | Portable Ice Maker |
|---|---|
| Ice Cube Size | Small, Medium, Large |
| Power Consumption | 120 watts |
| Material | Plastic |
| Color | White |
| Ice Shape | Bullet |
| Voltage | 120V |
| Ice Production Capacity | 26 lbs per day |
| Ice Storage Capacity | 2.2 lbs |
To Next Page
