OPERATION 9VX3
BEFORE STARTING THE ENGINE
The following items should be checked each day before start-up
or the start operations.
■ Walk-Around Inspection
Inspect the loose bolts, trash build up, oil or coolant leaks, broken
or worn parts. Inspect the condition of the attachments and the
hydraulic components.
Inspect the operator’s compartment for cleanliness. Keep it clean.
Inspect any cracks in boom and arm pivot area and cylinder
mounting brackets.
Repair if damaged.
Refer to Walk-Around Inspection in the Maintenance Section.
■ Lubrication
Perform the daily lubrication as required by the Lubrication Chart.
■ Pre-start Checks
Check all of oil, coolant and fuel levels.
Refer to the Daily in the Maintenance Section for more detailed
information.
3-2-1
To Next Page
Loading...
